The T142 drive belt is wider than T105 drive belt amking it the perfect choice for high power motors. Due to the low friction characteristics of the product, T142 drive belt has a shorter life than the drive belt included in the kit. If you use T142 drive belt with a modified motor, conduct maintenance regularly and replace the belt as necessary.
Material is softer than kit normal. Higher drive efficiency achieved by narrowed belt. Exclusive use for stock motor.
0.5mm thinner than kit normal(5mm). Usefull to make the width narrow.
Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.
New standard Short-type shock springs (20mm). We selected wire 1.4mm in diameter and accurately coiled and plated it. Gold: 5 Coils For high- grip asphalt road surface Made in Japan
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way.
Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (25 spline)
