T124 - C-BLADE PROTECTOR (4pcs/Black)

The shock tower Ver.B is made up after continuous feedback from Team INFINITY drivers in the worlds
Newly designed shock positions will provide you stable grip balance in various condition.
Perfectly suitable when you like to make the driving feel milder than kit normal.

This is a smaller foam bumper for the IF14 which features a chamfered leading edge making it more suitable for the latest breed racing body shells. SMJ zero gap tape can be used for fine tuning.

0.75mm thinner than kit normal(5mm). Usefull to make the width narrow.

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.

The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.

Aluminum spool outdrive with shining antiwear hard anodized coating. Made by 7075 T6 material.
Comparing normal type per car, approx. 6.8g light weight. Better throttle response achieved.
Use with C-Blade protector (T124) for drive shaft.

Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)

This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 9mm ones. The ball surface is smoother than that of the conventional one (T051), yet sold at a competitive price.

This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 7mm ones. The ball surface is smoother than that of the conventional one (T050), yet sold at a competitive price.

Cooling fan mount made of composite material that is half the weight of aluminum and super lightweight.

Motor mount and center shaft mount are assembled separately. Enable the chassis flex of motor mount area softer. Changing screw position, characteristics of flexibility can be adjusted. Additionally, characteristics of flexibility can be adjusted by changing screw position.