

IF14 pro gear diff set with aluminium outdrive cup specification. This set is about 2.2 grams lighter than the steel outdrive cup specification. This allows you to adjust the weight balance of the vehicle front and rear while also improving the throttle response.
It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.
Front of top deck: High-speed corner steering is increased. Low-speed corner steering decreased.
Rear of top deck: Increased rotation in the rear. Understeer is reduced. On power traction slightly reduced.
High precision and high strength stainless steel lower arm shafts plated with a special lubricant to reduce resistance and provide ultra smooth suspension movement. Offers ultimate suspension performance.
Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.
Front of top deck: Good balance between high-speed and low-speed corner.
Rear of top deck: Good balance between rotation and traction.
Titanium UFO head screw. Offers a lightweight design while maintaining sufficient contact surface area.