T311 - ALU HEX WHEEL HUB (4.0mm/Black/2pcs)

Narrower than kit standard (5mm). Aluminum hex wheel hub series. Width can be set more narrow.
When used on the front, it improves steering response. When used on the rear, it improves traction.

16 other products in the same category:

T261 - GRAPHITE FRONT BODY POST SUPPORT

This front bumper brace improves the rigidity of the bumper and body posts, helping stability around the front section at high speed. Made from lightweight and highly rigid carbon, the product surface is also specially embossed to achieve a stylish design which includes the INFINITY logo. Your IF14-2 will look even more dialled with this brace installed.

T269S - GRAPHITE UPPER BULKHEAD BRACE (Soft)

Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.

Front of top deck: Good balance between high-speed and low-speed corner.
Rear of top deck: Good balance between rotation and traction.

T268 - REAR BODY HEIGHT FITTER (for HBP)

When using the HBP mount it can be difficult to accurately position the rear body post holes in the bodyshell. By using this rear body height fitter it is quick and easy to precisely position the body post holes at the desired body height.

T123 - VZ REAR UPRIGHT (Graphite/Super Hard)

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

T162 - ALU ECCENTRIC BEARING HOLDER 0.5mm (Black/2pcs)

This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.