T308H - STEERING BLOCK / REAR UPRIGHT SET (IF14-2/Hard)

Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way.
Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (25 spline)

Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.

Front of top deck: High-speed corner steering is increased. Low-speed corner steering decreased.
Rear of top deck: Increased rotation in the rear. Understeer is reduced. On power traction slightly reduced.

Alignment tool to accurately assemble the IF14-2 lower bulkhead, upper bulkhead and shock tower.

High precision and high strength stainless steel lower arm shafts plated with a special lubricant to reduce resistance and provide ultra smooth suspension movement. Offers ultimate suspension performance.

Standard spur gear of the IF14-2 kit.

Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

A floating electronics plate which allows the receiver, ESC and motor cooling fan to be easily installed and removed from the chassis. Helps ease of maintenance and allows for quicker chassis changes.

By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.

A lightweight DJ CVD cross spider using high strength super duralium (A7075) to reduce the weight by approx 36% compared with standard steel. High durability is also achieved by applying a hard alumite treatment. Used in combination with T227LW lightweight DJ CVD joint it is possible to reduce the weight by about 2g per driveshaft.

The advanced "PRS system" is designed to deliver faster cornering speeds for the IF14-2. This system allows for the rear toe angle to be controlled passively as a result of the rear suspension arm stroke. The cornering characteristics can be fine-tuned by adjusting the mounting angle of the linkage rod.