T307H - LOWER SUSPENSION ARM SET (IF14-2/Hard)

A full set of lower suspension arms (hard) for IF14-2 and IF14-2FWD for one car.
This set is convenient when you want to replace lower suspension arms together for maintenance. It is also more economical than purchasing each item individually.

16 other products in the same category:

T162 - ALU ECCENTRIC BEARING HOLDER 0.5mm (Black/2pcs)

This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.

T112-41 - D.J.CVD DRIVE SHAFT 41mm

Short type (41mm) front drive shaft rather than the kit standard front drive shaft (42mm).
Offers a linear steering feel, making the car easier to drive when used in high traction or oversteer situations.

T301 - USP GRAPHITE FLEX FRONT SHOCK TOWER

By reducing the rigidity of the front shock tower connecting point to the upper bulkhead, the stiffness around the front bulkhead section is reduced and the overall chassis flex is increased, resulting in a calmer initial steering response. This reduction in initial stiffness helps smooth out cornering and can help reduce tyre wear.

T144 - WHEEL SHIM 0.5mm (SUS/8pcs)

By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.