T264 - BATTERY HOLDER WEIGHT SET (for Shorty Battery)

Brass battery holder weights designed for INFINITY IF14-2 to help balance the model when using shorty batteries.

*This product is designed to be used with batteries less than 95mm in length.

16 other products in the same category:

T123 - VZ REAR UPRIGHT (Graphite/Super Hard)

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

T227LW - LIGHT WEIGHT D.J.CVD JOINT (2pcs)

Lightweight DJ CVD joint that is approx 1.2g lighter than standard steel (approx 1.8g) by using lightweight and high strength super duralium (A7075). Throttle response is improved by reducing the rotating mass, while front tyre wear and understeer is reduced.

T121 - VZ STEERING BLOCK (Graphite/Super Hard)

Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

T302 - USP GRAPHITE FLEX REAR SHOCK TOWER

By reducing the rigidity of the rear shock tower connecting point to the upper bulkhead, the stiffness around the rear bulkhead is reduced and the overall chassis flex is increased allowing for smoother rear rotation. For normal body post.

T112-41 - D.J.CVD DRIVE SHAFT 41mm

Short type (41mm) front drive shaft rather than the kit standard front drive shaft (42mm).
Offers a linear steering feel, making the car easier to drive when used in high traction or oversteer situations.

T113 - D.J.CVD JOINT COVER TUBE (10x50mm/2pcs)

It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.