T146-AL - IF14 PRO-GEAR DIFF SET (Alu Outdrive/38T)

This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14-2.
Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.

This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.

0.75mm thinner than kit normal(5mm). Usefull to make the width narrow.

This front bumper brace improves the rigidity of the bumper and body posts, helping stability around the front section at high speed. Made from lightweight and highly rigid carbon, the product surface is also specially embossed to achieve a stylish design which includes the INFINITY logo. Your IF14-2 will look even more dialled with this brace installed.

Spare parts fot T358.
Hex socket head screws machined from high-quality 6-4 titanium material.
With a larger head outer diameter (approximately 3.7mm) than the typical button head, they allow for secure fastening of parts.

A full set of lower suspension arms (hard) for IF14-2 and IF14-2FWD for one car.
This set is convenient when you want to replace lower suspension arms together for maintenance. It is also more economical than purchasing each item individually.

Short type (41mm) front drive shaft rather than the kit standard front drive shaft (42mm).
Offers a linear steering feel, making the car easier to drive when used in high traction or oversteer situations.

Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.

Front of top deck: Good balance between high-speed and low-speed corner.
Rear of top deck: Good balance between rotation and traction.

Hex socket head screws machined from high-quality 6-4 titanium material.
With a larger head outer diameter (approximately 3.7mm) than the typical button head, they allow for secure fastening of parts.

When using the HBP mount it can be difficult to accurately position the rear body post holes in the bodyshell. By using this rear body height fitter it is quick and easy to precisely position the body post holes at the desired body height.

2.0mm graphite top deck for TE MID