T339 - GRAPHITE ONE-PIECE TOP DECK 2.0mm (IF14-2FWD)

Spare Part for IF14-2 Team Edition

Stainless steel shim with an inner diameter of 3 mm, outer diameter of 4 mm, and thickness of 0.1 mm.
The outer diameter is smaller than that of a standard shim while maintaining an inner diameter of 3 mm, allowing you to make adjustments to the clearance of shafts and other parts that were previously not possible.

C-hub for the IF14-2 platform that allows the upper arm mounting height to be 1mm lower than before. To achieve the same setup as the conventional C-hub (T011), add 1.0mm spacer under the 4.9mm ball end.

Slim head screw machined from high quality 64 titanium material. Replacing the steel slim head screws (B01308S) used to mount the rear chassis stiffener (T293) on the IF14-2FWD these will reduce weight and allow for fine chassis flex tuning. The wrench size used is 2.0 mm, and can also be tightened with a firm torque.

The standard screws for the IF14-2 kit available in 10pcs packs. The screws used in all INFINITY kits are made of high performance steel and made in Japan. They are extremely stable and strong when tightened. Recommended not only as a spare part but also as a setting option.

The standard screws for the IF14-2 kit available in 10pcs packs. The screws used in all INFINITY kits are made of high performance steel and made in Japan. They are extremely stable and strong when tightened. Recommended not only as a spare part but also as a setting option.

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.