T300 - LOW FRICTION DRIVE BELT 3x240mm

High precision and high strength stainless steel lower arm shafts plated with a special lubricant to reduce resistance and provide ultra smooth suspension movement. Offers ultimate suspension performance.

A lightweight DJ CVD cross spider using high strength super duralium (A7075) to reduce the weight by approx 36% compared with standard steel. High durability is also achieved by applying a hard alumite treatment. Used in combination with T227LW lightweight DJ CVD joint it is possible to reduce the weight by about 2g per driveshaft.

By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.

This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14. Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.

This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.

Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.

Front of top deck: Good balance between high-speed and low-speed corner.
Rear of top deck: Good balance between rotation and traction.