These aluminium axle height adjusters for the IF11 allow you to easily adjust the rear end ride height of your car for all conditions and tyre types. Used together with CM-A004-03 shim set you can adjust the height in increments of 0.1mm.
Ensured stable damping force due to the original -blend silicone oils we highly selected. Since viscosity is professionally controlled and produced, it is always possible accurate and stable setting.
Ensured stable damping force due to the original -blend silicone oils we highly selected. Since viscosity is professionally controlled and produced, it is always possible accurate and stable setting.
Ensured stable damping force due to the original -blend silicone oils we highly selected. Since viscosity is professionally controlled and produced, it is always possible accurate and stable setting.
This carbon rear axle for the IF11 ball differentials greatly improves throttle responses, especially on high-grip tracks.
Ensured stable damping force due to the original -blend silicone oils we highly selected. Since viscosity is professionally controlled and produced, it is always possible accurate and stable setting.
By using this graphite front arm, the front track width will be increased by 4mm (2mm each side) making driving on high-grip tracks more stable. Make sure to use F064 in combination with F063.
Ensured stable damping force due to the original -blend silicone oils we highly selected. Since viscosity is professionally controlled and produced, it is always possible accurate and stable setting.
0.5mm aluminium washer for use with F065 axle height adjuster to set rear ride height.
Ensured stable damping force due to the original -blend silicone oils we highly selected. Since viscosity is professionally controlled and produced, it is always possible accurate and stable setting.
These aluminium axle height adjusters for the IF11 allow you to easily adjust the rear end ride height of your car for all conditions and tyre types. Used together with CM-A004-03 shim set you can adjust the height in increments of 0.1mm.
