- New
CM-A002-300 - SILICONE DIFF OIL 30000 (60cc)
A new #30000, #40000 and #50000 has been added to the INFINITY silicon shock oil series.
This allows for a wider range of settings in all categories.
16 other products in the same category:
R0417 - ALU CHASSIS STIFFENER R (IF18-3)
By greatly increasing rigidity in the rear section of the chassis, the car's turning ability is noticeably reduced, making it easier to manoeuvre on extremely low-grip surfaces or high-grip surfaces where traction roll could be a problem.
T134 - ALU LOWER SUSUPENSION HOLDER -46.0 (0.5 Low)
The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
T122 - VZ REAR UPRIGHT (Hard)
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
T107 - REAR SHOCK TOWER Ver.B
The shock tower Ver.B is made up after continuous feedback from Team INFINITY drivers in the worlds
Newly designed shock positions will provide you stable grip balance in various condition.
Perfectly suitable when you like to make the driving feel milder than kit normal.
M095 - 45T DIFF SPUR GEAR
The 45T spur gear contributes to boosting the top speed of your vehicle and may potentially reduce fuel consumption under specific conditions. Additionally, it aids in achieving a smoother power delivery on low-traction tracks.
F116 - HYBRID STEERING KNUCKLE (3mm Trail)
Hybrid type with titanium axle shafts and duralumin steering knuckles.
Mild steering characteristics are achieved by setting the amount of trail at 3mm.
The thickness of the steering knuckle is 6mm, which allows for a wider range of ride height adjustment.
T132 - ALU LOWER SUSUPENSION HOLDER -40.0 (0.5 Low)
The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
R0382S25 - SWAY BAR STOPPER 2.7mm (IF18-3/2pcs)
New stabilizer stopper for IF18-3 front stabilizer.
By making the contact surface with the bearing spherical, smoother movement of the stabilizer is acheived.
Durability has also been greatly improved by using steel.
Available in 2.3, 2.5, and 2.7mm.
Compatible stabilizers
Stopper 2.3mm (R0382S23): 2.0mm, 2.1mm, 2.2mm, 2.3mm
Stopper 2.5mm (R0382S25): 2.4mm, 2.5mm
Stopper 2.7mm (R0382S27): 2.6mm, 2.7mm
A new #30000, #40000 and #50000 has been added to the INFINITY silicon shock oil series.
This allows for a wider range of settings in all categories.