R0394S6 - 6-8mm SLEEVE (IF18-3)
16 other products in the same category:
New axle shaft is high-duty concrete steel material used. Grind extremely to the limit and achieved light weight.
Fit together perfectly with the drive shaft material 7075 T6 made in Japan.
Black anodized drive shaft is light weight and "INFINITY" logo is marked.
M3 set screw is used at universal spider for simple operation.
Each parts are finished as possible as smooth that is with zero waste for further cornering speed and throttle response.
Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)
Spring holder for R0412 long life clutch spring (long type/11mm).
The surface is silver to distinguish it from the R0251-06 clutch spring holder (black).
Spare parts fot T358.
Hex socket head screws machined from high-quality 6-4 titanium material.
With a larger head outer diameter (approximately 3.7mm) than the typical button head, they allow for secure fastening of parts.
Cool carbon fiber ruler with 5-star INFINITY logo.
Made of carbon fiber, which is strong, lightweight, and has no distorstion due to heat, allowing for accurate measurements.
Available in two sizes: 15 cm and 30 cm.
The 6.33T front shock spring offers a slightly firmer suspension compared to the stock spring (6.67T). This adjustment serves to diminish front-end grip, resulting in a more forgiving driving experience.
