- New


In addition to the conventional 9, 10, and 11mm, the new 8mm is now available as a set with the necessary parts for installation!
By using 8mm, the outer wheel has more angle allowing for a wider range of settings.
R0259 Aluminum Servo Saver Set (top mount) is required.
Much-awaited for INFINITY 1/8 GP Racing kit user, the conversion kit for IF18 have finally unveiled ! !
Contents of "STAGE1" are mainly updating of rear section from previous INFINITY chassis.
With this conversion kit, super value of IF18 can be experienced.
Followed-up massive ease of maintenance for "STAGE2".
Revised drive train for better throttle feeling for "STAGE3".
Please take a gradual and evolutionary approach for your INFINITY.
World wining performance of INFINITY, get along together into the future.
(Parts for STAGE2 and STAGE3 are sold separately.)
The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
A special manufacturing process ensures long life and consistent performance.
As the overall length is approximately 11mm,
please use it together with R0413 CLUTCH SPRING HOLDER (for R0412).
New stabilizer stopper for IF18-3 front stabilizer.
By making the contact surface with the bearing spherical, smoother movement of the stabilizer is acheived.
Durability has also been greatly improved by using steel.
Available in 2.3, 2.5, and 2.7mm.
Compatible stabilizers
Stopper 2.3mm (R0382S23): 2.0mm, 2.1mm, 2.2mm, 2.3mm
Stopper 2.5mm (R0382S25): 2.4mm, 2.5mm
Stopper 2.7mm (R0382S27): 2.6mm, 2.7mm
Mounting a 30mm size cooling fan directly above the motor allows for efficient cooling of the motor.
(The 30mm size cooling fan is sold separately. <SMJ1188B> It is recommended to use the SMJ Super High-Speed Cooling Fan 30mm.)
The drivetrain of the IF18-3 has been lightened to improve response during acceleration and deceleration.
The weight is approximately 7g lighter than the 8mm shaft.
Not only has rigidity been increased by using A7075, but the pivot height has been raised by 2mm compared to the standard part R300B/300H, providing more responsive steering and changing the camber change rate. To ensure clearance inside the wheel, the ball has been downsized from 8.5 to 8.0mm and the screw cap from 10 to 9mm and tilted by 10°. A specially prepared 8mm titanium ball is included to ensure proper steering angle. The main body is hard anodized.
R0342 is made with carbon mixed material to greatly increase the rigidity of the parts. The rear upper arm and wheel shaft support are more rigid, and rear traction is improved at all speeds.
In addition to the conventional 9, 10, and 11mm, the new 8mm is now available as a set with the necessary parts for installation!
By using 8mm, the outer wheel has more angle allowing for a wider range of settings.
R0259 Aluminum Servo Saver Set (top mount) is required.