G275 - LIGHT WEIGHT ALU CENTER BULK SET (IF15-2/IF15-2W)

Repair parts for R0400

Repair parts for R0400

Spare part for G260

Spare part for G260

The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

Much-awaited for INFINITY 1/8 GP Racing kit user, the conversion kit for IF18 have finally unveiled ! !
 
Contents of "STAGE1" are mainly updating of rear section from previous INFINITY chassis.
With this conversion kit, super value of IF18 can be experienced.
 
Followed-up massive ease of maintenance for "STAGE2".
Revised drive train for better throttle feeling for "STAGE3".
Please take a gradual and evolutionary approach for your INFINITY.

World wining performance of INFINITY, get along together into the future.
(Parts for STAGE2 and STAGE3 are sold separately.)

The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.

Newly designed reviewing material and geometory. Durability is significantly advanced.

Spare part for G260

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

This part is crafted from 7075-T6 alloy, significantly enhancing the stiffness of the central diff mounting. Additionally, it improves heat dissipation and facilitates a smoother transmission, resulting in enhanced performance.

Mounting a 30mm size cooling fan directly above the motor allows for efficient cooling of the motor.

(The 30mm size cooling fan is sold separately. <SMJ1188B> It is recommended to use the SMJ Super High-Speed Cooling Fan 30mm.)

Spare part for G272.