This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (4.3 grams compared to the steel version's 8.3 grams) allows you to save weight and achieve maximum performance. It can also be installed on the rear hub. Using the M170 on the rear end of your vehicle provides additional support, which is recommended for high-grip and fast tracks.
Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.
Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
Revival of the plastic front body mounting plate that was a standard item on the INFINITY 1/8 racing first model and IF18. It subtly reduces the powerful front downforce from the body for smoother steering characteristics.
A special manufacturing process ensures long life and consistent performance.
As the overall length is approximately 11mm,
please use it together with R0413 CLUTCH SPRING HOLDER (for R0412).
M3x5mm and M3x12mm have been added to the popular INFINITY titanium slim head screw lineup.
They can now be used in more locations.
1/10 GP Touring Car World Championship
At the 2018 IFMAR 1/10 GP Touring Car World Championship (1/10 IC Track), five cars made it to the A main final, qualifying TQ and winning the championship. Four years after that amazing debut, at the 2022 IFMAR World Championship, nine IF15 prototypes made it to the A main final, qualifying TQ, Superpole, and winning, proving their overwhelming potential. The IF15 prototypes that achieved these amazing results are finally being made commercially available as the IF15-2!
The IF15-2, the most advanced 1/10 GP touring car in history and will take your racing to new heights!
Let's aim for the top together!
Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
R0342 is made with carbon mixed material to greatly increase the rigidity of the parts. The rear upper arm and wheel shaft support are more rigid, and rear traction is improved at all speeds.
Adjustment tool that fits directly onto clutch nuts such as IF18-3 and IF15-2. The flat top surface makes it easy to apply force when tightening the nut and enables easy installation even with hard clutch springs.
Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)
New axle shaft is high-duty concrete steel material used. Grind extremely to the limit and achieved light weight.
Fit together perfectly with the drive shaft material 7075 T6 made in Japan.
Black anodized drive shaft is light weight and "INFINITY" logo is marked.
M3 set screw is used at universal spider for simple operation.
Each parts are finished as possible as smooth that is with zero waste for further cornering speed and throttle response.
This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (4.3 grams compared to the steel version's 8.3 grams) allows you to save weight and achieve maximum performance. It can also be installed on the rear hub. Using the M170 on the rear end of your vehicle provides additional support, which is recommended for high-grip and fast tracks.
