F115 - MOTOR COOLING FAN MOUNT SET

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

Spare part for G272.

Approx. of 13g heavy weight than kit normal carbon graphite chassis. Suitable for the car to make more lower gravity center like carpet or high-grip surface.
Optimized chassis shape design will provide perfect chassis flex.

The belt roller set will prevent skipping of rear belt of IF14.
When it occurs deflection under huge load on the belt, helps the belt to keep at proper position.
It provides stability of traction and brake control. It lengthens the life of belt.
※No combined usage with T095 REAR BALANCE WEIGHT.

Spare part for G260

Not only has rigidity been increased by using A7075, but the pivot height has been raised by 2mm compared to the standard part R300B/300H, providing more responsive steering and changing the camber change rate. To ensure clearance inside the wheel, the ball has been downsized from 8.5 to 8.0mm and the screw cap from 10 to 9mm and tilted by 10°. A specially prepared 8mm titanium ball is included to ensure proper steering angle. The main body is hard anodized.

The most advanced ""PRS system"" will deliver faster cornering speed for IF14. As a result of the stroke from suspension arm, toe angle is controled passively. Amount of toe angle is fine-tuned by the mounting angle of the linkage rod.
Rear caster angle is -2 deg.

Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (0.65 grams) allows you to cut weight from your transmission and achieve maximum performance. It can be installed on all the differentials of your vehicle.

R0342 is made with carbon mixed material to greatly increase the rigidity of the parts. The rear upper arm and wheel shaft support are more rigid, and rear traction is improved at all speeds.

The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.

Prevents the side belt from falling off when a heavy load is applied to it.