• New

F115 - MOTOR COOLING FAN MOUNT SET

Mounting a 30mm size cooling fan directly above the motor allows for efficient cooling of the motor.

(The 30mm size cooling fan is sold separately. <SMJ1188B> It is recommended to use the SMJ Super High-Speed Cooling Fan 30mm.)

16 other products in the same category:

  • New

R0415 - HARD PLASTIC FRONT BODY MOUNT SET

Revival of the plastic front body mounting plate that was a standard item on the INFINITY 1/8 racing first model and IF18. It subtly reduces the powerful front downforce from the body for smoother steering characteristics.

  • New

R0417 - ALU CHASSIS STIFFENER R (IF18-3)

By greatly increasing rigidity in the rear section of the  chassis, the car's turning ability is noticeably reduced, making it easier to manoeuvre on extremely low-grip surfaces or high-grip surfaces where traction roll could be a problem.

  • New

R0382S23 - SWAY BAR STOPPER 2.3mm (IF18-3/2pcs)

New stabilizer stopper for IF18-3 front stabilizer.
By making the contact surface with the bearing spherical, smoother movement of the stabilizer is acheived.
Durability has also been greatly improved by using steel.
Available in 2.3, 2.5, and 2.7mm.

Compatible stabilizers
Stopper 2.3mm (R0382S23): 2.0mm, 2.1mm, 2.2mm, 2.3mm
Stopper 2.5mm (R0382S25): 2.4mm, 2.5mm
Stopper 2.7mm (R0382S27): 2.6mm, 2.7mm

T107 - REAR SHOCK TOWER Ver.B

The shock tower Ver.B is made up after continuous feedback from Team INFINITY drivers in the worlds
Newly designed shock positions will provide you stable grip balance in various condition.
Perfectly suitable when you like to make the driving feel milder than kit normal.

  • New

G272 - HYBRID SERVO SAVER SET (IF15-2/IF15-2W)

The combination of carbon and aluminum materials provides sharp steering characteristics with a highly rigid and lightweight finish. In addition, the included 4.9mm ball and aluminum spacer optimize bump steer and increase corner speed.

T122 - VZ REAR UPRIGHT (Hard)

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.