R0402 - CAP SCREW 9mm (IF18-3)
16 other products in the same category:
Not only has rigidity been increased by using A7075, but the pivot height has been raised by 2mm compared to the standard part R300B/300H, providing more responsive steering and changing the camber change rate. To ensure clearance inside the wheel, the ball has been downsized from 8.5 to 8.0mm and the screw cap from 10 to 9mm and tilted by 10°. A specially prepared 8mm titanium ball is included to ensure proper steering angle. The main body is hard anodized.
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
Mounted in the opening at the rear of the main chassis, it increases chassis rigidity at the rear end of the chassis and increases weight by approximately 13g to ensure stable rear grip. It is also effective when the track surface is high grip and traction roll occurs.
Use with G230 Carbon Rear Stiffener Set to expand the range of setting.
R0342 is made with carbon mixed material to greatly increase the rigidity of the parts. The rear upper arm and wheel shaft support are more rigid, and rear traction is improved at all speeds.
Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)
The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
New stabilizer stopper for IF18-3 front stabilizer.
By making the contact surface with the bearing spherical, smoother movement of the stabilizer is acheived.
Durability has also been greatly improved by using steel.
Available in 2.3, 2.5, and 2.7mm.
Compatible stabilizers
Stopper 2.3mm (R0382S23): 2.0mm, 2.1mm, 2.2mm, 2.3mm
Stopper 2.5mm (R0382S25): 2.4mm, 2.5mm
Stopper 2.7mm (R0382S27): 2.6mm, 2.7mm
Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.
This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (0.65 grams) allows you to cut weight from your transmission and achieve maximum performance. It can be installed on all the differentials of your vehicle.
Hybrid type with titanium axle shafts and duralumin steering knuckles.
Mild steering characteristics are achieved by setting the amount of trail at 3mm.
The thickness of the steering knuckle is 6mm, which allows for a wider range of ride height adjustment.
M3x5mm and M3x12mm have been added to the popular INFINITY titanium slim head screw lineup.
They can now be used in more locations.
A special manufacturing process ensures long life and consistent performance.
As the overall length is approximately 11mm,
please use it together with R0413 CLUTCH SPRING HOLDER (for R0412).
