- New


This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (4.3 grams compared to the steel version's 8.3 grams) allows you to save weight and achieve maximum performance. It can also be installed on the rear hub. Using the M170 on the rear end of your vehicle provides additional support, which is recommended for high-grip and fast tracks.
Spring holder for R0412 long life clutch spring (long type/11mm).
The surface is silver to distinguish it from the R0251-06 clutch spring holder (black).
Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)
Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
Weight has been reduced by F:0.3g R:0.5g, removing this unnecessary material has improved rotational balance. Reduced clearance in the thrust direction helps maintain wheel stability during running.
A new #30000, #40000 and #50000 has been added to the INFINITY silicon shock oil series.
This allows for a wider range of settings in all categories.
Mounted in the opening at the rear of the main chassis, it increases chassis rigidity at the rear end of the chassis and increases weight by approximately 13g to ensure stable rear grip. It is also effective when the track surface is high grip and traction roll occurs.
Use with G230 Carbon Rear Stiffener Set to expand the range of setting.