• New

T355 - ALU REAR LOWER SUSPENSION HOLDER -LEFT 40.0mm

16 other products in the same category:

F114 - ALU FRONT BODY POST/WING MOUNT

When removing and attaching the front wing, it is no longer necessary to remove the upper monocoque, allowing for smooth wing replacement. Additionally, since it also serves as a front body post mount, the position of the body post does not change depending on the type of wing, making it convenient.

  • New

M098 - CENTER DIFF MOUNT (ALU/2pcs)

This part is crafted from 7075-T6 alloy, significantly enhancing the stiffness of the central diff mounting. Additionally, it improves heat dissipation and facilitates a smoother transmission, resulting in enhanced performance.

  • New

A2530 - INFINITY CARBON RULER (30cm)

Cool carbon fiber ruler with 5-star INFINITY logo.
Made of carbon fiber, which is strong, lightweight, and has no distorstion due to heat, allowing for accurate measurements.
Available in two sizes: 15 cm and 30 cm.

  • New

G286 - STAINLESS REAR STIFFENER SET(IF15-2)

Mounted in the opening at the rear of the main chassis, it increases chassis rigidity at the rear end of the chassis and increases weight by approximately 13g to ensure stable rear grip. It is also effective when the track surface is high grip and traction roll occurs.
Use with G230 Carbon Rear Stiffener Set to expand the range of setting.

T112 - D.J.CVD DRIVE SHAFT 42mm

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2