This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (0.65 grams) allows you to cut weight from your transmission and achieve maximum performance. It can be installed on all the differentials of your vehicle.
Made of superior quality 1.6mm thickness of U.S.A. carbon material.
Compare with kit normal thickness 2.0mm, further chassis flex is gained and initial steering response can be increased.
Provides great efficiency use with optional Aluminum Flex Main Chassis(T109).
Spare parts fot T358.
Hex socket head screws machined from high-quality 6-4 titanium material.
With a larger head outer diameter (approximately 3.7mm) than the typical button head, they allow for secure fastening of parts.
The 45T spur gear contributes to boosting the top speed of your vehicle and may potentially reduce fuel consumption under specific conditions. Additionally, it aids in achieving a smoother power delivery on low-traction tracks.
The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (4.3 grams compared to the steel version's 8.3 grams) allows you to save weight and achieve maximum performance. It can also be installed on the rear hub. Using the M170 on the rear end of your vehicle provides additional support, which is recommended for high-grip and fast tracks.
Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)
