- New


The 1.1mm spring provides a firmer tension compared to the standard IFB8 kit clutch spring (1.0mm), enabling the clutch to engage at higher RPM and enhancing engine bottom-end power, particularly on high-traction tracks.
A new #30000, #40000 and #50000 has been added to the INFINITY silicon shock oil series.
This allows for a wider range of settings in all categories.
Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)
Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
By greatly increasing rigidity in the rear section of the chassis, the car's turning ability is noticeably reduced, making it easier to manoeuvre on extremely low-grip surfaces or high-grip surfaces where traction roll could be a problem.
This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (0.65 grams) allows you to cut weight from your transmission and achieve maximum performance. It can be installed on all the differentials of your vehicle.
The 1.1mm spring provides a firmer tension compared to the standard IFB8 kit clutch spring (1.0mm), enabling the clutch to engage at higher RPM and enhancing engine bottom-end power, particularly on high-traction tracks.