M150 - AIR FILTER FOAM (6pcs)

Spare part for G260

Mild and easy-to-control characteristics can be obtained when running on high-grip surfaces and large high-speed tracks.
G272 Hybrid Servo Saver Set is required.

The combination of carbon and aluminum materials provides sharp steering characteristics with a highly rigid and lightweight finish. In addition, the included 4.9mm ball and aluminum spacer optimize bump steer and increase corner speed.

Repair parts for R0394

Repair parts for R0394

The 45T spur gear contributes to boosting the top speed of your vehicle and may potentially reduce fuel consumption under specific conditions. Additionally, it aids in achieving a smoother power delivery on low-traction tracks.

New axle shaft is high-duty concrete steel material used. Grind extremely to the limit and achieved light weight.
Fit together perfectly with the drive shaft material 7075 T6 made in Japan.
Black anodized drive shaft is light weight and "INFINITY" logo is marked.
M3 set screw is used at universal spider for simple operation.
Each parts are finished as possible as smooth that is with zero waste for further cornering speed and throttle response.

The drivetrain of the IF18-3 has been lightened to improve response during acceleration and deceleration.
The weight is approximately 7g lighter than the 8mm shaft.

R0342 is made with carbon mixed material to greatly increase the rigidity of the parts. The rear upper arm and wheel shaft support are more rigid, and rear traction is improved at all speeds.

Cool carbon fiber ruler with 5-star INFINITY logo.
Made of carbon fiber, which is strong, lightweight, and has no distorstion due to heat, allowing for accurate measurements.
Available in two sizes: 15 cm and 30 cm.

IFB8 shock stroke and rebound gauge. Allows easy measurement of important shock length while mounted on the vehicle during suspension setup. Supports stroke from 60mm to 150mm. Can also be used on vehicles other than IFB8.

Hybrid type with titanium axle shafts and duralumin steering knuckles.

Mild steering characteristics are achieved by setting the amount of trail at 3mm.

The thickness of the steering knuckle is 6mm, which allows for a wider range of ride height adjustment.

Repair parts for R0394

The 23T steering servo horn, crafted from 7075-T6 alloy, offers exceptional robustness and precision. Featuring an M2 screw lock, it virtually eliminates play between the servo horn and servo, resulting in heightened steering precision and responsiveness.