DISCONTINUED
Team Infinity T-shirt USA edition. As worn at the 2019 IFMAR 1:8 ONROAD WORLD CHAMPIONSHIPS.
The screws and E-rings included in the IF18-2 kit are now available for sale as individual items. The screws used in the INFINITY kits are made of high strength steel and made in Japan. The fit when tightened is perfectly matched to the IF18-2. Recommended as standard and also setting parts.
Ensured stable damping force due to the original -blend silicone oils we highly selected. Since viscosity is professionally controlled and produced, it is always possible accurate and stable setting.
Slim head screw machined from high quality 64 titanium material. For direct replacement of the steel rear body mount screws (R0120) of the IF18-2 and IF15W. Both lightweight and look cool.
DISCONTINUED
Team Infinity T-shirt USA edition. As worn at the 2019 IFMAR 1:8 ONROAD WORLD CHAMPIONSHIPS.
Spare parts fot T358.
Hex socket head screws machined from high-quality 6-4 titanium material.
With a larger head outer diameter (approximately 3.7mm) than the typical button head, they allow for secure fastening of parts.
Stainless steel shim with an inner diameter of 3 mm, outer diameter of 4 mm, and thickness of 0.1 mm.
The outer diameter is smaller than that of a standard shim while maintaining an inner diameter of 3 mm, allowing you to make adjustments to the clearance of shafts and other parts that were previously not possible.
The standard screws for the IF14-2 kit available in 10pcs packs. The screws used in all INFINITY kits are made of high performance steel and made in Japan. They are extremely stable and strong when tightened. Recommended not only as a spare part but also as a setting option.
Wheel reamer to widen the hole diameter of 1/8 GP racing car wheels to the optimum size.
If the wheel and axle shaft are too tight, it can cause problems such as not being able to install the wheel correctly or not being able to change tires efficiently during pit stops.
This wheel reamer is used by threading it through the hole in the wheel while turning it.
INFINITY silicone diff oil, formulated from pure silicone oil and carefully manufactured under strict viscosity control to provide the stability when making setup changes. Now available in 3000, 7000 and 9000 versions. The lineup now includes 3000 to 10000 in increments of 1000, allowing for finer tuning of the differential depending on track conditions.
Team Infinity T-shirt USA edition. As worn at the 2019 IFMAR 1:8 ONROAD WORLD CHAMPIONSHIPS.
The screws and E-rings included in the IF18-2 kit are now available for sale as individual items. The screws used in the INFINITY kits are made of high strength steel and made in Japan. The fit when tightened is perfectly matched to the IF18-2. Recommended as standard and also setting parts.
This tool enables you to cut and then easily chamfer the ends of plastic body posts up to 6mm in diameter.
DISCONTINUED
This parts case consists of two parts cases and a hard outer case. Convenient for storing spare parts such as option parts while leaving some space for bigger items.
DISCONTINUED
A high-precision acrylic setting board that is a 'must have' for checking your cars ride height and wheel alignment.
This cool looking board features a special sticker with the INFINITY logo. Available in vertical or horizontal layouts depending on your needs.
Uses high quality 8mm thick clear acrylic board made in Japan.
300x440mm in size making it ideal for 1/10 scale.
A 20pcs pack of button head screws, as used in the Aluminum & Titanium Screw Set. High rigidity 7075 material is used allowing you to tighten the screws firmly. A great value pack.
DISCONTINUED
Team Infinity T-shirt USA edition. As worn at the 2019 IFMAR 1:8 ONROAD WORLD CHAMPIONSHIPS.
