There are 12 products.
Front upper arm spacer for IF15. By inserting these shims between the front upper arm holder and the upper deck its possible to fine tune the roll center and camber change rate, enabling smooth and high speed cornering.
This is a new optional part designed to increase the IF15-2's longitudinal rigidity, thus increasing on power traction and adding rear stability.
This part was used by all 9 IF15-2 prototypes that made it to the A main final at the IFMAR 1/10 IC World Championships in Thailand in 2022.
Optimized shape to accommodate the updated thickness of (G187) front knuckle plate (hard) adopted on IF15-2. Additionally, reducing the clearance of the opening compared to the original product to efficiently control the airflow, which is the original purpose of the knuckle plate.
This is a new optional part that increases the rigidity of the rear section of the IF15-2, offering further tuning options for all track conditions.
By inserting it from the upper side of the main chassis, the additional parts do not protrude in any way from the underside which leaves and neat and clean look.
Facilitates adjustment to reduce vehicle width when using wide offset tires.
Oversized wheel hubs to better fit tires with large wheel hex mounting. Prevents misalignment and increases wheel stability. (Matrix tires recommended).
Sharper turning and more direct performance can be obtained on high-grip circuits.
Prevents the side belt from falling off when a heavy load is applied to it.
Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)
