By installing this Front Carbon Wheel Plate on the front knuckle, turbulent air generated in the front wheels during driving is cleaned up offering more stable driving characteristics. The effect is especially noticeable on high-speed circuits.

This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.

Upper arm holder machined from 7075 aluminuim material. The strength and rigidity are increased providing higher corner speed in certain conditions. The black anodized finish complete with Infinity logo also add a cool look to your car.

A carbon stiffener that can be added to the front lower arm to increase rigidity. Increased steering response and higher cornering speeds can be achieved in certain conditions. Its also possible to adjust the flex and rigidity by the number of mounting screws used.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

The material and coating have been updated to significantly improve crash resistance and durability compared to the standard items. The shaft is highly durable and resistant to scratches even after long periods of use.

The material and coating have been updated to significantly improve crash resistance and durability compared to the standard items. The shaft is highly durable and resistant to scratches even after long periods of use.

A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)

An all new front one way set featuring larger one way bearings for improved durability. The timing of the drive transmission to the front tires has also been changed resulting in milder and more easy to drive characteristics. The overall weight has been reduced to 24g, 4g lighter than the original.