Standard part for IF18-2

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

This set of Φ8.5mm titanium ball screws is for use with the IF18-2. (Set includes 4 normal size and 2 long size) For smooth and light driving.

Front Shock Stay LD(Lay Down) that offers a position one step lower than the conventional R0081 (included in the kit). The center position of the R0336 is the same as the lower hole of the R0081. It's designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.

Front Shock Stay LD(Lay Down)WIDE features a position 2mm wider each side than the R0336. Offers increased initial response than R0336. It is designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.

Compared to the standard plastic rear body mount, this new carbon mount increases the height of the body by 3mm (Almost the limit within the regulation of IFMAR). In addition, the cross-sectional shape of the carbon plate and A7075 adapter matches the latest body shapes such as XTREAM's Diablo and Protoform's R19 without any gaps. This allows the downforce to be transferred to the tires without loss and improving rear grip. The left and right carbon plates can be fine-tuned with set screws to accommodate individual body shapes. The connection to the car body can be made in three step width directions, and also absorbs the twisting of the mounting part when toe-in is applied.

Spare part for R0337

Spare part for R0337

Spare part for R0337

Spare part for R0337

Spare part for R0337