There are 12 products.
IFB8 shock stroke and rebound gauge. Allows easy measurement of important shock length while mounted on the vehicle during suspension setup. Supports stroke from 60mm to 150mm. Can also be used on vehicles other than IFB8.
Prevents the side belt from falling off when a heavy load is applied to it.
This part is crafted from 7075-T6 alloy, significantly enhancing the stiffness of the central diff mounting. Additionally, it improves heat dissipation and facilitates a smoother transmission, resulting in enhanced performance.
Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)
Mounting a 30mm size cooling fan directly above the motor allows for efficient cooling of the motor.
(The 30mm size cooling fan is sold separately. <SMJ1188B> It is recommended to use the SMJ Super High-Speed Cooling Fan 30mm.)
The most advanced ""PRS system"" will deliver faster cornering speed for IF14. As a result of the stroke from suspension arm, toe angle is controled passively. Amount of toe angle is fine-tuned by the mounting angle of the linkage rod.
Rear caster angle is -2 deg.
The combination of carbon and aluminum materials provides sharp steering characteristics with a highly rigid and lightweight finish. In addition, the included 4.9mm ball and aluminum spacer optimize bump steer and increase corner speed.
Steering knuckle plate for IF15-2 and IF15-2W, which allows for a greater steering angle of the outer tire in corners than the standard kit version.
This will make tighter cornering possible, and can improve high speed steering on larger tracks.
A new #900 has been added to the INFINITY silicon shock oil series.
This allows for a wider range of settings in all categories.
New stabilizer stopper for IF18-3 front stabilizer.
By making the contact surface with the bearing spherical, smoother movement of the stabilizer is acheived.
Durability has also been greatly improved by using steel.
Available in 2.3, 2.5, and 2.7mm.
Compatible stabilizers
Stopper 2.3mm (R0382S23): 2.0mm, 2.1mm, 2.2mm, 2.3mm
Stopper 2.5mm (R0382S25): 2.4mm, 2.5mm
Stopper 2.7mm (R0382S27): 2.6mm, 2.7mm
